Development Kit 2 Contents
**************************

The following is a list of contents that should be in the package you received. Make sure you have all the components and if something is missing, please contact your salesperson at SiMa.ai:

* MLSoC Developer Board
* USB Type C cable
* USB Power Brick
* Ethernet Cable
* USB to 6 pin USB FTDI cable
* 2 1000Base-T module for SFP
* 32GB SDCard

Booting up the MLSoC Developer Board
************************************

In this section we will set up the host system to communicate with the MLSoC Developer Board using the appropriate serial port. The board can be set up in standalone or PCIe mode. 

Development Kit 2 in Standalone Mode
------------------------------------
To set up the board in standalone mode, make sure all four dip switches are in ``ON`` position as shown in the image below.

 .. image:: media/devkit2_standalone_mode.png
       :scale: 30%
       :align: center
       :alt: Development Kit 2 in Standalone Mode


Development Kit 2 in PCIe Mode
------------------------------
To set up the board in PCIe mode, make sure the first dip switch is in ``OFF`` position and dip switches #2, #3, and #4 are in ``ON`` position as shown in the image below.

.. image:: media/devkit2_pcie_mode.png
       :scale: 30%
       :align: center
       :alt: Development Kit 2 in PCIe Mode


**Steps**

#. Power up the board by connecting one end of the 12V Type-C to Type C data cable (power cable) from the power brick to 12V power connector and the other end to the AC outlet.

#. Connect the 6-PIN connector to the UART port and the other end to your host machine.

#. By using a serial device connector like ``minicom`` in Linux and macOS or ``Tera Term`` in Windows, connect to the board USB using a speed of 115200 baud rate, 8 data bits, no parity bits, 1 stop bit and no flow control. 
   See :ref:`Initial Board Setup` for details.

#. You should see the following:

    .. code-block:: console

        sima-user@sima-user-machine:~$ sudo minicom -D /dev/ttyUSB2 -b 115200, 8n1 -w
            Welcome to minicom 2.8

            OPTIONS: I18n 
            Port /dev/ttyUSB2, 15:56:28

            Press CTRL-A Z for help on special keys


            davinci login: 

#. Log in with username ``sima`` and password ``edgeai``:


    .. code-block:: console

        davinci:~$

.. note::

   We suggest that you change the password.
    #. Run ``passwd`` and press ``Enter``.
    #. Enter ``edgeai`` as the old default password followed by your new password.
    #. Remember to note down your new password.